Customer States They Were Involved In Road Rage
Customer states and mechanical problems in one digestible video for you to enjoy!
In todays episode we see 2 engines that have snapped cranks, a couple of cars that have some non factory holes in them and many other crazy mechanical nightmares. Enjoy!
Send us your customer states and mechanic fails videos here:
forms.gle/ybywj6a3SS4Vpvhv5
Or email:
mechanicalnightmarebiz@gmail.com
Follow us on Instagram:
/ mechanicalnightmareyt
Follow us on Facebook:
/ mechanicalnightmareyt
Video descriptions:
0:00 Intro
0:04 Should've bought a v8 instead
0:19 The amount of broken or incorrect TPMS sensors is far too common
0:31 I wish the mechanic asked the backstory on what really happened
0:42 Customer states "my friend rotated my tires for me and now my car drives weird”
0:52 The 2nd snapped crank I've seen this week this one a diesel Volvo
1:04 This video was just after they tried to top up the oil to see if it would fix it, I bet there's a nice big hole in the block or oil pan
1:17 I don't know how they didn't notice how bad this wheel bearing was while fixing the brakes
1:30 I'm thinking it had extremely low tire pressure and then had been driven on for a while
1:36 Donkey was protecting them from seeing all the errors
1:43 That's a first time I've seen this one
1:48 I would consider this a bit more than just a road rage incident if I was them
1:58 Poor Landcruiser I'm going to blame poor maintenance on this one
2:06 Found out what that suspension knocking noise is
2:17 This engine does not sound healthy at all with a bit of knocking, that first cylinder seems to be the culprit
2:31 At least it was an easy fix
2:40 That's some nasty sounding timing chain noise
2:49 This squirrels going to be mad when he finds all his food storage has been removed
2:54 At least the engine mounts aren't the most urgent while they fix the stolen catalytic converter
3:04 Who knows how long the engines been running like this for
3:21 Let us know what you think it could be in the comments below!
3:37 I would think a air leak but seeing as it stops after a short while I have no clue
3:47 Unfortunately will be a blown head gasket or cracked head
3:51 Customer was driving when all of a sudden it started doing this. Definitely a misfire going on
4:04 Well that's going to smell in a few days if they didn't pull the carpet out
4:09 Outro
#customerstates #mechanicfail #mechanicproblems
I'm shocked 90% of this wasn't fixed by spray foam.
Engine noise: Belt, accessory bearing or vacuum leak?
I'm more leaning towards idler pulley, had a similar problem on my F250 5.8l. It would start to make noise like just sitting in the drive thru but when I'd power brake it it would go away. I happen to have 2 extras and replaced NO MORE NOISE !!!
I would never touch a truckers gallon jug bare handed.
Don’t
0:47 how did they tighten those nuts backwards? the round flange is bigger than the hex. Vicegrips, or were they just hand tight? Or maybe this is the new one-way security nut?
3:21. My guess is a vacuum leak or the idler pulley. I couldn't see the car, but that engine is a 2zz. My daily is a 1zz celica. I haven't worked with the 2zz's too much. I can't tell which side of the engine bay the sound is coming from.
I was thinking an idler pulley as well. But, of course, without being there, hard to tell. But I think you are right.
I work on atv's and it still blows my mind how these people put on the lug nuts backwards!!! 🤯🤯
damn that guy that was involved in that road rage incident was lucky
Engine noise: Idler bearing maybe. I've also had a few alternator clutch pulleys with same symptoms.
Back in my day we did stupid shit, now I do smart shit.
I experienced the same sound on an old clio. One of the metal tabs mounting the ecu under the bonnet/hood was partially cracked. The noise was the fatigued metal rubbing at low rpms. Went silent at higher revs. Might be something similar.
I was just wondering, is the inner gear in your channel logo the front chainring of a bike with a 1x drivetrain?
Ive had a similiar blown out tire on a trailer once, it was to heavily loaded and got to hot.
3:23 I‘d say that‘s a failed valve cover. Or at least the pcv part of it is clogged or broken. Can also sound like a chirping bird on some cars at idle
I lived the air leak in the Peterbilt.😂
3:05 When somebody wedges a funnel in there...
If I was forced to guess, I think the weird noise is from the brake booster check valve. Going away as more vacuum is applied on reverse.
engine noise probably from a tiny vacuum leak, had that happen on a lawnmower engine and it sounded like a duck quacking at idle
That destroyed tire, I did similar once. It was a spring thaw, I'm zipping down the road at about 65 and hit a huge pothole. My tire looked a lot like that one.
1:35 "do not drive backwards over those spikes
i absolutely amazes me to see people putting nuts on backwards, how special can you actually be.
2:54 - 3:04 ... that engine was twerkin'.
Some of the take away from these videos are most people are idiots and there are way too many guns
🤯 These clips are always from America 🇺🇸. So what do you expect ?...
@@alancrisp1582 bast part is. The most gun crimes are where they are the most restricted.
@@Ghaustersource: trust me bro
@norbertnagy5514 I am American. I know many of the gun laws we have to deal with. I also know where the laws are the most restrictive on ownership in the country. NYC is about the worst. Carry permits are done by county and some attitude was to even charge officers who are outside their county where they work, until the law enforcement officers safety act was passed as a federal law.
@@norbertnagy5514source, reviews of gun crime, and gun laws. If you take away Houston, Chicago, New York and LA, suddenly the gun crime rate in the US drops to the middle of pack by country
What’s happening on the second to last one
That sound at 3:21 is probably a misaligned Finnegan Pin.
3:30 sounds like a pcv valve
Do Landcruisers have 4 bolt mains?
For 3:34 sounds like and exhaust leak, bad Pulley, or bad belt
I believe that noise is The tensioner pulley
The noise is probably a stretched belt or bad tensioner.
That's that new Bluetooth crankshaft
Insane! 😃
The noise is probably due to a leak in the intake, located in between the throttle body and the cylinder head.
For the first one... was for the best. Now put a freaking v8 in it.
2:45 Subaru Outback 😎
A new engine require if only he thay would and fixed it would have been s expensive
They wouldn't have needed a new engine if they didn't have a lead foot.
That's why I have a lexus plus a lead foot so I don't have to worry about it blowing up or costing much to fix.
@@swagmalone8092 Your lead foot will eventually make that Lexus decide to quit.
@@ColtonRMagby Where I live a brand new second hand 3.5 v6 costs $400 (including labor) to replace so it's probably alright
@@swagmalone8092 For now.
High pressure fuel pumps can be noisy @ idle
I heartily agree with you sharing the watch stats from your vids! Unfortunately it probably won't do much with the state of the platform in question. Great luck to you! Here's hoping!
Did you really say a 2 liter Camero?
Sounds like it. Ecotec LTG: 2 Litre I4 turbocharged, 205kW/275hp
That's what I was thinking to and then remember my 82 berlinetta v6 which was a 2.8 so....
Did you really write "Camero"?
The newest ones are 2.0 turbo. Just rented one in Hawaii, and as much as I was displeased getting a 4 cylinder Camaro (wanted a V6 or v8 mustang ", I have to admit it takes off like a rocket. It's a low end plus high end turbo, so the first one give boost right away. Head and shoulders faster than the 87 trans am I used to gave, just that lame sound though. 275 hp isn't bad at all.
Unfortunately I did... apparently they aren't too bad but who doesn't love a good old V8
2 liter camaro........🤮
Every single vehicle I have has a faulty TPMS. Just ignore it
serves that person right for having a non v8 camaro
How would putting the lugs on backwards make the tire wobbly or make the car drive poorly? Isn't it still threaded the other way?
Lug nuts are tapered on one side so that they fit into the holes on the wheels.
@@user-hw3mt8ep5d ah… so it never really gets tight or torqued all the way. That makes sense.
Or centralised@@morganpethis3960
Harmonic balancer, rubber drying out to make it squeak....
You steal "the other guy's" catch phrase and some of his clips...SHAME!!!
I think the same people submit clips to both channels, so there's overlap.
@@sometimesleela5947 look at his playlist and hidden videos. copyright removed. he steals them
Who the f is that
For the engine noise, just remove the squeaky toy. That should do it
What's the point in even driving a 2 liter Camaro?
I am like number 173
Wow ,how exciting for you 👦 your mom must be so proud of you ?..
Nobody gives a rat's ass.....
I'm working on my channel, but I don't know the upload time. What do you think is the most time spent on KZhead?
🤫🤔 And you are trying to piggyback off his channel ?. So cheeky 😝 !..
HOLD THE CAMERA SIDEWAYS AND HOLD IT STILL AND GET RID OF THE NARRATOR
0:53 oh you ask or thumb down? no problem.
You just steal everyone’s clips from Reddit without permission?
oh man can the voice over sound any more annoying and fake
Evap. system noise?