How to Calculate the Circuit Breaker Size ? | Breaker Sizing and Selection
2021 ж. 12 Мау.
39 800 Рет қаралды
In this video I have explained about How to Calculate Circuit breaker size with circuit breaker sizing chart .
Learn About DG sizing : • Diesel Generator Size ...
• Function of AVR in Gen...
#Breaker_Sizing#Breaker_Selection
Thank you sir, you have explained very well, I can gain a lot of knowledge by watching the whole video
Clear explanation, good ❤👍
Nice explanation..... 👍
thank you sir,also apload cable sizing and selection
Usefull❤
Great Video sir.. please upload video on voltage drop calculation and Selection of No. of cable runs
Very informative, thanks for sharing it with us...dl
Very nice
Too much informative.
You are the best
Thank you so much
Sir here u considered power factor 0.8 but I want to know onething if my power factor is 0.98 after correction can i consider 0.98 power factor for it. And one more thing if my connected load is 25kw but demand load for the same connected load is 20kw so for breaker sizing which load I should take to size the breaker.
Sir nice video,i have a question. Does the total sum of amper of outgoing circuit breaker must equal to the main circuit breaker àmper?thanks
wich cb is recommended for 40KVA diesel generator using 3phase
Good job and well explained.
Real power/apparent power
nice
PLEASE SHOW THE BOOKS TO REFER THE SIZING OF MCB&SF UNITS USED IN PANELS
Wow !
How to determine the load 2+40+... =76 right? How to calculate that
👍🏻❤
What about utilization factor u must consider
8:11
What about DC Breaker?
How to calculate power factor?
Please 1.25 what value clear explain.
Kindly please Clear me on 1.25 Value how Calculated
(Eg:-20A) Adding 25% means of 0.25 of 20A= 5A, then add the 5A on 20A = 25A (Or) (20*1=20 , 0.25*20) any number multiply to 1is that number. So 1.25
the safety factor is not 25% this is 125% =1.25
I like your lecturer but you jammed some steps you didn’t show how you find the voltage 415?
A three phase is usually rated 415v as its standard...
Wrong approach: Calculate the FLC for single motors shall be separate and not to combine with 3-phase motors
allso i need cable sizing