KZhead

Table saw out feed Work Bench build 1623

Edward’s Family Workshop
2023 ж. 22 Ақп.
3 345 Рет қаралды
Жүктеу

I'm excited to present this video of the brand new Work Bench that I just built. I wanted to keep it relatively simple and light weight. I don't need a bench over complicated, I just needed a 4x8 work surface that also doubles as an out feed for my table saw. I do a lot of work with epoxy so I wanted to incorporate levelling casters into the build. Link down below. I might in the future put in shelves down below but for the time being this will serve me just fine. I do plan on putting in some dove tail channels or possibly dog holes to help me clamp work pieces in place. Not sure which way I'll go but I'll definitely make a video showing that process.
Thanks again for watching!
Levelling casters with ratchet
www.amazon.ca/gp/product/B09L...

Пікірлер

  • Nice job! Thanks for sharing

    @PostMortem66@PostMortem66 Жыл бұрын

    • Thanks for watching!

      @edwardsfamilyworkshop@edwardsfamilyworkshop Жыл бұрын

  • Good job man! 👍 Well explained.

    @ljcruz127@ljcruz127 Жыл бұрын

    • Appreciate the comment😄🙏

      @edwardsfamilyworkshop@edwardsfamilyworkshop Жыл бұрын

  • Good Job 👍

    @donniehodge2548@donniehodge2548 Жыл бұрын

    • Thank you 🙏

      @edwardsfamilyworkshop@edwardsfamilyworkshop11 ай бұрын

  • I stuck around to see how the table saw was supported, but you didn’t show that part.😢😢 Beast of a workbench though. Nicely done!

    @dottielynch9763@dottielynch97638 ай бұрын

    • Thanks for watching and the kind words. I just built a simple support out of 6 pieces of 2x4. Nothing fancy at all.

      @edwardsfamilyworkshop@edwardsfamilyworkshop8 ай бұрын

  • Thank you kindly😁

    @edwardsfamilyworkshop@edwardsfamilyworkshop Жыл бұрын

  • Nice job keep it up

    @mustaphakhattabi7163@mustaphakhattabi7163 Жыл бұрын

    • Thanks, will do! 😊

      @edwardsfamilyworkshop@edwardsfamilyworkshop Жыл бұрын
KZhead