Machete Restoration - Knife Transformation [Ebony Brass Handle]

Anyone who likes extremely rusty, old things will love this restoration. More precisely, it is more of a transformation from a machete to a knife. I had to do a lot of work on the lathe, grinding, drilling, tapping, electrolyzing, hardening and a lot more... Since the original handle of this antique machete was no longer there at all, I had to make a new one out of ebony with brass caps. The pitting caused a lot of damage to the machete, so the knife ended up looking old and new somehow! Stay tuned and have fun watching!
▶ What did I do?! ◀
Use a needle scaler to remove the crust of rust, that was really a lot of rust. This is then removed more deeply with electrolysis. Since the rust was already far too advanced, I could no longer save the machete in its original form and converted it into a knife. It gets its contour on the belt sander and the cutting edge is processed. During hardening, the knife is heated to 800 °C and quenched in preheated oil. The metal must then be tempered three times for one hour in an oven at 200°C. Since the old handle no longer exists, I remade it from ebony and brass caps; I did everything with the lathe and milling machine. Finally everything was assembled and the cutting edge was sharpened; Now nothing stood in the way of testing the knife.
▶ Good to know ◀
I used the following tools: needle scaler, water, glass container, salt, laboratory power supply, scriber, angle grinder, belt grinder, pen, caliper, hardening oven, immersion heater, thermometer, blacksmith tongs, oil, spatula, wire brush, oven, center punch, cordless screwdriver, drill, thread cutter, Cold bluing, abrasive fleece, lathe, turning chisel, boring bar, milling cutter, milling machine, two-component glue, file, sandpaper, grinding stone
▶ Special thanks to my channel members! ◀
-
▶ Do you want to support me? ◀
Would you like to become a channel member? Then you can do this here:
/ @forgottenshinerestora...
Do you like what you saw and want to help the channel develop further? If you want to support me, you can donate via Paypal:
www.paypal.com/donate?hosted_...
or use the following affiliate links:
Material to work with:
Metabo bench grinder: amzn.to/46rrkxL
Metabo cordless screwdriver BS 18 LTX-3 BL: amzn.to/43833JV
Metabo bit set: amzn.to/3pzwV4n
Rust remover: amzn.to/3vdQ52f
Pin punch: amzn.to/3NEn1qX
Drill rods: amzn.to/3TFFOWD
Equipment:
Camera Sony AX-53 amzn.to/3XHqI2J
Ring light amzn.to/3rhgj1Q
Microphone Rode amzn.to/44vlFF1
DJI Gimbal Camera amzn.to/3O1YjkJ
Affiliate links cost you nothing, I only receive a small share from the seller, you have no disadvantage.
▶ Did you like it? ◀
Did you like the video? Then like, subscribe and share, please!
Thank you!