DIY Fullering Dies for a Hydraulic Forging Press | Blacksmithing
Subscribe to @RedBeardOps for more knife making and bladesmithing content!
Instagram: / redbeardops
Twitter: / redbeardops
Facebook: / redbeardops
#redbeardops #blacksmith #knifemaking
**********************************************************
A Notice from Red Beard Ops LLC: The information provided on this channel is for entertainment purposes only. Any action you as the viewer takes upon the information on this channel is strictly at your own risk, and Red Beard Ops LLC will not be liable for any losses, damages, or personal injuries in connection with the use of this content (including injuries, damages, or losses sustained while you were trying to emulate the actions and projects on this channel). Attempting to emulate any of the actions or projects put forth by this channel should not be done without training and even then, at your own risk.
Crushin' it...
lol
What was the point of using the lathe when you cut off the section you turned?
I used the lathe to scribe a line to target cutting along with my saw
Squeesh
Gets the job done for sure!