Jd Squared Model 32 Bender First Thoughts
2020 ж. 4 Там.
23 979 Рет қаралды
Check out my Amazon Store www.amazon.com/shop/influence...
You can Support This Channel on Patreon www.patreon.com/user?u=271681...
Looking at the model 32 tube bender from JD Squared. I got the bender and hydraulic package from KMS tools when it came on sale. That was a huge factor for me. buying local and not having to pay shipping made things a lot cheaper. Jd squared has a huge selection of dyes which made the decision even easier. I think everybody should have a tube bender personally
Sound effects by Epidemic Sound
epidemicsound.com
Royalty-free music by Epidemic Sound
epidemicsound.com
Nice .. This will be at the top of my list for Santa !
They are super nice to have on hand. The air over hydro is the only way to go.
Now that looks pretty handy.....
That’s slick!
Greta video! I just setup my model 32 and that same large pin is struggle to get in and out but has gotten better
The more you use it the looser it gets
I have the same bender and i have one question about it. How i can find out calibrated clr with out bend tech software?
How big the compressor would be good
Good Day, thanks for the informative video... was wondering if you have a direct way I can contact you. Would like to ask you a few questions regarding your model 32 bender.
I finally got one...putting it together and I have an extra part (a spacer?)... At 1:14 in your video, you have the very part sitting on top of the bender. Did you find a use for that?
Looks like he has it under the die
Is it possible to buy the manual version and then get the hydraulic as a add on later?
Yes you can as the hydraulic kit comes with the change over parts, I know the cost is way higher but you’ll thank yourself for it
ive been looking at them contemplating if i want one, think ill pull the pin on it in the future just alot of investment right now when you need atleast 4 dies with it to be able to recoupe any money and have options when building different tasks, i like the square dies too i typically prefer building with square tube on my rigs to be unique as everyone uses round tube
no I totally hear you when a die is like 400 bucks, I know jd squared has square dies, however I wouldn't be surprise if all benders this style can interchange dies
@@TestDontguess i havent really seen any others of this style, if you find any cheaper dies to let me know, also the best place/way to purchase in canada would be good info, the machine isnt bad at 300-400$ without the cylinder, up to you if you buy their cylinder or find your own if hand bending get too tedious its the dies that are the killer i know they need to be precise and all but its just a couple chunks of steel i dont see it costing them over 80$ to make them in NA probably half that in the east
I purchased from KMS tools as they usually go on sale a few times a year
How the heck do you get accurate bends on this thing, I struggle to get the right centre measurements
it takes practice plus having software makes it easier
@@TestDontguess may i ask, what software do you use?
Nice , sure beats a manual version .
You need one at the camp