BUILD A DIY SPOT WELDING MACHINE
2023 ж. 13 Мам.
1 915 935 Рет қаралды
Only $2 for 5 pcs PCBs and Free SMT Assembly at JLCPCB& Get $54 for New Users: jlcpcb.com/cyt
In this video, I'll show you how to make a spot welding machine from an old microwave oven
Used Component-
1. Transformer from an old oven
2. 10mm copper wire (2 meter)
3. Timer circuit
4. Copper Bar
5. Wooden base
6. 12 AWG Silicon Wire
7. Push button
8. 20amp Fuse
Thanks for watching
No explanation at all. It would have been much better if you had given a tutorial and with purchasing details of where to buy the digital timer
I have done about 50% of building a spot welder from oven transformer. Output test about 3.6v. I think it take me a day for all. Thank you so much
Nice tutorial for diy spot welder. It is a clear and full video. Your skill is very well.
The value of these videos is priceless. Thank you so much for making such detailed tutorials! Next, can you make a video on how to make a Flux Capacitor for a Delorean? 😄
Although I am fine with soldering my 18650 or using a holder for it. However I am impressed with the way, you have built the spot welder. Kudos.
OK thanks for sharing your project, I have the parts and prepared my transformer so IU will built it tomorrow.
Nice technique for making the electrode clamps.
Glad that you're back again!!!
excelente trabajo, muy bien hecho gracias por ello desde España
This project is very good!
You made a mistake in executing the welder machine.
quick question, the cable that you used in the secondary winding, I noticed toy used 2 core of that size cable, can you tell me what sort of current you were expecting to get out of that transformer and what voltage, and since you used that size cable why did you reduce it in the size that went to the welding tip
Apne bhaut accha device banye hai. I like your work🎉🎉🎉
Amazing well done that works perfect. I saw some coments asking for the size of electrodes, this is not a welding machine this is spot welding no needs electrodes
Very good video Tapendra bhai. nice project. How much will it cost ? can you give an approximate budget?
I made the same thing, with the same module in my channel. It worked 😊
What are the copper plates glued to?
Your work is so clean...❤
if you put a coil with 2-3 turns on the end it could also double up as an induction heater
Great work!