Prusa i3 Mk3 not printing well? Give your hot end a tune up!
2022 ж. 5 Сәу.
11 948 Рет қаралды
✅ RECOMMENDED 3D PRINTERS ▶. www.amazon.com/shop/outpostpo...
Need to tune up your Prusa i3 MK3s? Here is my go-to list of checks and tune-ups to fix printing problems and get back online.
INSERT NEW TIMING LATER
Thanks for watching!
*** Some product links are affiliate links which means if you buy something we'll receive a small commission at no charge to you.
Big smile after that outro :D Keep on learning!
Thanks for the video MJ!
Good teaching!! There's some room for improvement with camera stability and focus, but I'm sure this will come naturally a few videos down the line. Thanks! :)
Great video, Thank you!
thank you for the informations i like your chanel , keep going :)
Thank you for your video. Have been struggling since replacing my bed thermistor with prints that start off ok then fail due to filament not getting fed into the print head. Multiple cold pulls and still filament fails after about an hour of printing. Ideas?
you should know that white filament wears out the nozzle about 6 times faster than black because of the things used to make the colors. white uses titanium which has quite big chunks
What kind of bed are you using?
I don't get why my 2 in 1 out hotend is only blocked on one side. I can push filament through it manually but it gets to a point where it won't come out anymore. But on the other extruder on the same nozzle it's fine? It doesn't make sense to me.
just change your nozzle lol
this option is cheaper