Nice video, well done, thank you for sharing it with us :)
@Bianchi778 ай бұрын
Perfect work sir , i learned alot from your video
@raaooffpublic602611 ай бұрын
New subscriber here. Hello sir. May I know what solder flux and solder lead are you using? Also the soldering iron temperature? Soldering tip? It's a big help for me to know these as I am having problem with the IC I want to replace. Thanks a lot in advance.
@justbehappy9617Ай бұрын
Nice
@TechnicalUmesh110 ай бұрын
Can I use hair dryer instead of heat gun? Or any alternative method to remove smd component if not having heat gun? Kindly guide brother.
@imintuitive34727 ай бұрын
cheap air reflow station cost no more than a good quality hair dryer. I don't think hair dryer gets hot enough.
@ericastier16466 ай бұрын
what heat temperature and air flow ?
@nutrajangyee48069 ай бұрын
There is no standard for what to use. I personally prefer 400°c and 30-40% airflow and solder them in 10-15 seconds. These chips can take a beating
@Negiku14 күн бұрын
Nice Hmm najs : D
@medvidekpetr43975 ай бұрын
Puedo apostar que esa pistola de calor no tiene no aire ni calor.
@lucianorenteria1481Ай бұрын
Heat temperature?
@bvdmedia10 ай бұрын
360
@mafia672410 ай бұрын
@@mafia6724 that's pretty high. 320 is safer to avoid thermal shock damages on ic.
@ericastier16466 ай бұрын
Looks so hard 🤭🫡
@Sdreaasmit5 ай бұрын
That’s what she said !!!
@mrBDeye4 ай бұрын
mdr not pro
@fredfred71692 ай бұрын
Worst soldering video I’ve ever seen
@onlyseanss3 ай бұрын
Can you than please recommend a good one? I am trying to learn.
Nice video, well done, thank you for sharing it with us :)
Perfect work sir , i learned alot from your video
New subscriber here. Hello sir. May I know what solder flux and solder lead are you using? Also the soldering iron temperature? Soldering tip? It's a big help for me to know these as I am having problem with the IC I want to replace. Thanks a lot in advance.
Nice
Can I use hair dryer instead of heat gun? Or any alternative method to remove smd component if not having heat gun? Kindly guide brother.
cheap air reflow station cost no more than a good quality hair dryer. I don't think hair dryer gets hot enough.
what heat temperature and air flow ?
There is no standard for what to use. I personally prefer 400°c and 30-40% airflow and solder them in 10-15 seconds. These chips can take a beating
Nice Hmm najs : D
Puedo apostar que esa pistola de calor no tiene no aire ni calor.
Heat temperature?
360
@@mafia6724 that's pretty high. 320 is safer to avoid thermal shock damages on ic.
Looks so hard 🤭🫡
That’s what she said !!!
mdr not pro
Worst soldering video I’ve ever seen
Can you than please recommend a good one? I am trying to learn.
Кошмар.