The rheostat was not adjusted at any time..does it mean u left it at a point where u get a maximum current
@KennethBegold-jp1mw11 күн бұрын
And i left it where the maximum current was achieved before starting
@mrwise131511 күн бұрын
the deflection of my galvanometer is only in one direction what could be the cause?
@chrisapathy62024 күн бұрын
Check you connections again. Your connection is wrong
@mrwise13152 күн бұрын
Dont forget to subscribe. Thanks
@mrwise131511 күн бұрын
After the connection, the galvanometer deflected at both ends, but I didn't get a balance point on the galvanometer i.e the deflection was stationary on the galvanometer. Please what should I do?
@faidahadeoye6539 күн бұрын
It will definitely reach the balance point. Hope you are moving the jockey from 0cm to get your balance point with that it will balance. But if you are moving it from 100cm it will not balance
@mrwise13159 күн бұрын
Try and subscribe
@mrwise13159 күн бұрын
Bravo, how can I get the procedures to the practical?
@bukkyakinlabi79078 күн бұрын
@@bukkyakinlabi7907 is on the video.
@mrwise13158 күн бұрын
It was adjusted before i started the experiment
@mrwise131511 күн бұрын
Was that ur preferred condition?
@KennethBegold-jp1mw10 күн бұрын
@@KennethBegold-jp1mw Yes. But after the connection if they is no deflection on both side,you need to adjust it and check again.
Don't forget to subscribe. Thanks
Well done Sir. On point.
Don't forget to subscribe
The rheostat was not adjusted at any time..does it mean u left it at a point where u get a maximum current
And i left it where the maximum current was achieved before starting
the deflection of my galvanometer is only in one direction what could be the cause?
Check you connections again. Your connection is wrong
Dont forget to subscribe. Thanks
After the connection, the galvanometer deflected at both ends, but I didn't get a balance point on the galvanometer i.e the deflection was stationary on the galvanometer. Please what should I do?
It will definitely reach the balance point. Hope you are moving the jockey from 0cm to get your balance point with that it will balance. But if you are moving it from 100cm it will not balance
Try and subscribe
Bravo, how can I get the procedures to the practical?
@@bukkyakinlabi7907 is on the video.
It was adjusted before i started the experiment
Was that ur preferred condition?
@@KennethBegold-jp1mw Yes. But after the connection if they is no deflection on both side,you need to adjust it and check again.