KZhead

Fowler 2"-6" Dial Cylinder Bore Gauge Set Review

Catus Maximus
2018 ж. 30 Мау.
19 163 Рет қаралды
Жүктеу

Here is a review of the 2 to 6 in, .0005 resolution Fowler dial cylinder bore gauge set . .

Пікірлер

  • Thanks 3:11 - 3:26 is what I needed to know.

    @kylekenan2321@kylekenan23215 жыл бұрын

  • The problem with using these of a mill or lathe sometimes is that there’s no room at the end of the bore to get these in. So you have to disturb the set-up to take the measurements. So if you’re boring a hole, these may not be usable. For that, an internal mike would be a better choice. But if you have the room, these work very well.

    @melgross@melgross2 ай бұрын

  • The gauge is for measuring +/- If you let it swing past 6:00 you keep adding ie: if it spins past 6:00 and reaches 15 again then you are +40

    @MrStukez@MrStukez5 жыл бұрын

  • Good vid, thanks for the instructions, tips and ideas.

    @petejoseph8257@petejoseph82574 жыл бұрын

  • Got the same one, thanks for the video. My question is, when i spun the handle out, the inner rod and spring came out. I've got it put back in where I think it should be but is the a breakdown anywhere of that spring/rod inside the handle? Thanks in advance.

    @mathewshackelford8037@mathewshackelford80373 жыл бұрын

  • Why is it missing two pieces?

    @POliver8888@POliver88883 ай бұрын

  • 👍

    @modern-instrument@modern-instrument Жыл бұрын

  • Why do they all come with missing pieces there's indentions in the casings but there is no tool

    @jamesbarnes7045@jamesbarnes70452 жыл бұрын

    • Because they're in the tool...

      @TheGamersRace@TheGamersRace Жыл бұрын

    • @@TheGamersRace I'm talking about the long one at the end that one's definitely not inside the tool

      @jamesbarnes7045@jamesbarnes7045 Жыл бұрын

    • @@jamesbarnes7045 the sheet explains if the set is in inches there will be no tool there. read man, read.

      @ono147@ono147 Жыл бұрын

  • Hate dial gauges....why? Pain to read, but doable. Not really an issue, however? I often deal with having to switch from Imperial/SAE to Metric. Often multiple times in the same application. 2 Engines I have lately worked on: 4G54 Astron (Mitsubishi) and Ford 4.0l SOHC Cologne...both use constant swapping of tolerances. Yeah, I could do both in one tool with conversion. But I hate having to have a calculator with me. Just more BS to deal with.

    @MrAcuta73@MrAcuta734 жыл бұрын

    • There's also the much rarer dual needle dial which read both metric and fractional at the same time

      @CatusMaximus@CatusMaximus4 жыл бұрын

  • is fowler made in USA?

    @derick3482@derick34824 жыл бұрын

    • The one I got amazon for $99 is made in china

      @TheStephenspann27@TheStephenspann274 жыл бұрын
KZhead