Here’s a video on some of the bits and settings I use for cutting and engraving aluminum. Sorry for the camera angles not sure what happened.
Here’s a video on some of the bits and settings I use for cutting and engraving aluminum. Sorry for the camera angles not sure what happened.
Interesting that the 1/4 bit seemed to have the most audible chatter, but has the cleanest surface finish. Then again, I am new to this, so maybe I am listening for the wrong thing...
You’re definitely hearing it correctly. I’m no expert either but perhaps the larger diameter has something to do with it. Also the router is much louder at 15,000 rpm’s as opposed to 12,000 with the 1/8” bit. Thanks for watching!