How to fabricate clear retainers and aligners from 3D printed dental models
2023 ж. 24 Ақп.
13 010 Рет қаралды
This video shows you how to make clear retainer and aligners from 3D printed dental models.
The scissors are from Beck
beckinstruments.com/product-c...
Plastic is in the video is Zendura
www.zenduradental.com/
Learn more at orthodontics.io/
can you make a video of separate the aligners from the models without cutting them off?
Why is mine flexible like rubber Is it gonna work ?
I am currently working on the same work 2 years experience 😊
❤
Can I know the thickness of retainer...mine is 1mm and it is very hard...and difficult to put... should I use or tell my orthodontis..plz help
1mm is a common one but we use a thinner plastic which is close to 0.76mm.
@@PersonalizedOrthodontics thank you so much 😊😊
How do you separate the aligners from the models without cutting them off?
A little silicon as a separating agent and the vertical cut. Having a small height model is the key.
@@PersonalizedOrthodontics Thanks, where do you place vertical cuts?
@@wakesurfidaho straight between the two part of the arch. If you are holding the model in front of you facing up. The cut goes from the bottom to top close to the front teeth. Then roll the plastic to the sides from lingual/palatal to the buccal - twist clockwise each side.