The Boss and I take down a bad mill! #aermotor #windmill
Пікірлер
You think I could weld a nut to a snapped vane spring mount to get it off?
@jacksonstephens9772Ай бұрын
I'm assuming you mean the part that sticks out of the base of the motor that you slip the spring onto from the tail. In that case, I don't see why that wouldn't work! I would try a pipe wrench on it. Probably would get it off, too!
@yourlocalwellmanАй бұрын
Was the replacement a new or rebuilt motor?
@kmeyer55987 ай бұрын
This one happened to be a rebuilt motor!
@yourlocalwellman7 ай бұрын
How much water daily in gallon's are you getting and how much gallons per minute douse it give approximately ?
@johnykurmis32716 ай бұрын
That depends on a decent amount of variables, what size the check and plunger are, how deep the well is, and what motor head they have one but on average a 2 3/4 plunger can pump 3-5 gallons a minute on a good day
@yourlocalwellman6 ай бұрын
Hi, i am from Argentina and i have a question. How can i know where my aermotor windmill will can has a scape of oil? And how can i fix it? Thanks
@santiagopenonori62996 ай бұрын
Hi! And are you meaning there's a leak that you can't find?
@yourlocalwellman6 ай бұрын
What's shot about this one?
@theozarkhillbilly90407 ай бұрын
Little gears in the back went out, so the two sets weren't touching!
@yourlocalwellman7 ай бұрын
@@yourlocalwellman wow. How many years you reckon its been up and running?
@theozarkhillbilly90407 ай бұрын
It's hard to tell. I couldn't find a date stamp on it, but probably in the 20-25 year range if oiled properly
You think I could weld a nut to a snapped vane spring mount to get it off?
I'm assuming you mean the part that sticks out of the base of the motor that you slip the spring onto from the tail. In that case, I don't see why that wouldn't work! I would try a pipe wrench on it. Probably would get it off, too!
Was the replacement a new or rebuilt motor?
This one happened to be a rebuilt motor!
How much water daily in gallon's are you getting and how much gallons per minute douse it give approximately ?
That depends on a decent amount of variables, what size the check and plunger are, how deep the well is, and what motor head they have one but on average a 2 3/4 plunger can pump 3-5 gallons a minute on a good day
Hi, i am from Argentina and i have a question. How can i know where my aermotor windmill will can has a scape of oil? And how can i fix it? Thanks
Hi! And are you meaning there's a leak that you can't find?
What's shot about this one?
Little gears in the back went out, so the two sets weren't touching!
@@yourlocalwellman wow. How many years you reckon its been up and running?
It's hard to tell. I couldn't find a date stamp on it, but probably in the 20-25 year range if oiled properly