Millions of chainsaws are sawing crookedly from this. TOP bus and circuit faults

Millions of chainsaws are sawing crookedly from this.
What to do if crooked saws Chainsaw. This is a kind of TOP bus and chain faults.
☑ MANUAL KIT FOR CHAIN ​​CARE - ali.pub/2ubdqo
✂︎- - - - - - - ✂︎ - - - - - - -✂︎
1. The chainsaw can crookedly cut due to uneven wear of the chain teeth. Pebbles, nails, etc. may fall under the chain saw teeth. If the chainsaw chain is not undermined.
the chain will stretch, and the tire will wear unevenly.
The teeth of the chain are skewed by this, the wear of the chain shanks and the edges of the chainsaw tires occurs.
2. Chainsaw can crooked sawing due to incorrectly or at the wrong time the tensioned chain.
Chainsaw chains need to tighten according to the instructions. According to the instructions, the chainsaw chain must be tightened so that when you try to lift it, you can see the bottom of three teeth.
But, with different tire lengths and finger strength, it works poorly.
A properly tensioned chain on a cold chainsaw should not arbitrarily sag and should not scroll without effort.
After a short work of the chainsaw. The chain heats up and sags slightly. This is normal.
Do not rush to pull it up. Because after the circuit has cooled. She can become overtightened.
3. A dull chain on a hot chainsaw under load quickly stretches.
4. Overtightened chain when working chainsaws also quickly stretched. In addition, the tire wears quickly. and bearings.
Can this be fixed?…. In most cases, YES
Stupid chain chainsaw with uneven wear sharpen stationary machine.
A tire for the first time you can just flip. If you have already turned over and on your tire uneven wear on both sides - We will dub.
To align the tire chainsaw, we need a square, a vice, a Bulgarian and a new trimming circle.
Check the chainsaw tire with a square. And if necessary, remove a little grinder as shown in the video.
Check that the chain shanks are completely hidden in the groove of the tire - if the groove has become a small tire to replace.
If the chainsaw is not worth the catcher chain, and the tire is elongated .... the chain can cause serious injury to the ankle by wound on its
If the chain has jumped off repeatedly on a star the deep grooves are formed.
Getting into the furrow, the chain sags, jumping out of it strongly pulls. If you already have something similar, change the star.
Otherwise, the chain may break, the bearings crumble, the sprocket welded to the clutch disc may not stand up and fall off - something similar happened with this asterisk.
Even a new one may break due to improperly installed connecting strips at the riveting point.
The rivet will be slightly larger or lighter. And check if the connecting bars of the chain are correct.
On some chains on the slats an arrow indicates the direction.
If the arrow is not, the correctness of the installed strips can be determined by the front support of the slat.
She will be more than the back. Incorrectly set one connecting strap chain chainsaw, will go to a bias. The load on the connecting link will increase, and the rivet will not stand. Chainsaw chain breaks.
Watch the condition of the asterisks and chains at your chainsaw. And do in a timely manner the repair of tires chainsaws.
✂︎- - - - - - - ✂︎ - - - - - - -✂︎
💰 How to make money on Aliexpress - EPN Affiliate Program EARNINGS on Aliexpress - ePN Affiliate - ali.pub/2ubyb4
💗 Likecoin - cryptocurrency for likes: likecoin.pro/@sadko777/wux8/gsk1